Door hinges are opened and closed more than 10 times a day on average in people's lives, so the quality of a hinge depends on the performance of your furniture. Choosing the hinge hardware in your home also requires great attention.
The quality of the door hinge can be distinguished from the following three aspects:
1. Surface: Check if the surface material of the product is flat. If scratches and deformations are seen, it is produced from waste materials (scraps). This type of hinge has an unsightly appearance and makes your furniture look tasteless.
2. Hydraulic performance: As we all know, the key to a hinge is to act as a switch, so this is very important. The key comes from the damper of the hydraulic hinge and the rivet assembly. The damper mainly depends on whether there is noise during opening and closing. If there is noise, it is a low-quality product. It also depends on whether the turning speed is uniform. Is the hinge cup loose? If there is looseness, it indicates that the rivet is not tightly fastened and is prone to detachment. Close it a few times and check if the indentation in the cup is obvious. If it is obvious, it proves that there is a problem with the thickness of the cup material, which is prone to "bursting the cup".
3. Screws: Generally, the hinge has two screws, both of which belong to the adjusting screws, up and down adjusting screws, front and back adjusting screws. Some new hinges also have left and right adjusting screws, which is the so-called three-dimensional adjusting hinge. Generally, it has two adjusting stations. Tip: Use a screwdriver to adjust the up and down screws three to four times with some force, then remove the screws and check if the teeth of the hinge arm are damaged. This hinge arm is made of iron material and is not as hard as screws, which is prone to wear and tear. Additionally, if the precision of the factory's tapping is not enough, it is easy for the screws to slip or fail to tighten. The front and rear adjusting screws are also tested as such.