The password setting for fingerprint lock usually involves several key steps: entering the setting mode, adding users, setting passwords, and confirming passwords. The following is a detailed step-by-step explanation:
1. Enter the setting mode: Different fingerprint locks may have different ways to enter the setting mode. Generally speaking, you need to press a specific button, such as the ENT key, or other preset combination keys. Some fingerprint locks may require you to enter the administrator password to enter the setup mode.
2. Add User: In the settings mode, you need to select the "User Settings" option and then choose "Add User". This will take you to the add user interface.
3. Set password: In the add user interface, you will see several options, including adding password, fingerprint, and magnetic card. Select 'Add Password' and then follow the prompts to enter your new password. Usually, the password length should be between 6 and 12 digits, and it needs to end with the # key.
4. Confirm password: After entering the new password, you need to re-enter it to confirm. If the password entered twice is the same, the system will prompt you that the password has been successfully set.
The above steps are applicable to most fingerprint locks, but the specific operation may vary slightly depending on the brand and model. Therefore, it is best to refer to the specific user manual or contact the manufacturer for the most accurate guidance.
Setting the password and fingerprint for a fingerprint lock usually involves several basic steps, including initialization, entering the password, and entering the fingerprint. The following are the specific steps for organizing:
initialization
Firstly, we need to press the touch button on the motherboard to start initialization.
Enter password
1. Press the "Add" button.
2. "Enter the management password and end with #".
After entering the management password, enter the door opening password and press # to confirm.
4. Re enter the door password and press # to confirm.
Enroll fingerprint
1. Press the "Add" button and enter the "management password ending in #" after the prompt sound.
2. Then press the fingerprint.
After the first successful input, it will prompt "re-enter", and then press the fingerprint again to successfully input.